![]() It’s especially helpful to go out right after it rains. Once that debris is pushed off to the side of the road, many times it will resurface previously buried arrowheads. Pay special attention to the areas that have recently been scraped or leveled. As mentioned earlier, modern roads often times follow the trails that Native Americans originally created. I know of many arrowhead hunters, myself included, that like to walk along dirt roads and look in the ditches for artifacts. Don’t disregard a possible spot to hunt just because it’s near a road! Dirt Roads and Roadside Ditches Many roads today follow old Native American trails. They would probably want to have their camp near a trail or walkway. Is there an area that would provide natural shelter from the weather, like an overhang or something similar. Perhaps an area that is elevated and out of the flood plain, like on a nearby knoll would be a place to consider. Once a good water source is located, think about what other factors might have been advantageous to the people living there. The largest factor in determining what kind of rock was most common is knowing what part of the country you’re hunting arrowheads in. But it’s difficult to say which type of rock was most common. It’s these stone arrowheads and other old Indian rock tools and artifacts that have survived and which we’re able to find hundreds and even thousands of years later.Īs mentioned earlier, many different types of stones were used to make arrowheads. Stone lasts forever and does not decay like bone and antler. However, when we talk about arrow heads today, we generally only refer to those arrowheads that were made out of stone. At times, the best material they had available to make these tools were not only stones, but bone and antler as well. What Are Arrowheads Made Of?Īmerican Indians were known for using the best material available for making tools like arrowheads and spear tips. By doing this, they would carve out the gaps, or notches, that the Native Americans would use to attach the arrowhead to the shaft of the arrow. Notches in the arrowhead were made by using a combination of pressure flaking and abrading, or grinding. ![]() The final step in the arrowhead making process was called notching.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |